 |
6204KA/C3 Bearing |
11,29,2016 |
|
6204KA Bearing |
11,29,2016 |
|
6204/C4 Bearing |
11,29,2016 |
|
6204/C3 Bearing |
11,29,2016 |
|
6204 Bearing |
11,29,2016 |
|
6204 Bearing |
11,29,2016 |
|
Bearing 204TN-Z |
11,28,2016 |
|
Bearing 204KA-Z |
11,28,2016 |
|
Bearing 0204 |
11,28,2016 |
|
Bearing 180204 |
11,28,2016 |
|
| News details |
Rolling bearing the use of the correct method of loading and unloading
|
| Time：2016.11.18 News Sources：Shandong Xinkaite bearing Co.,Ltd. Views：
|
Rolling bearings belong to the precision parts of machinery and equipment. The machine supports the decision-making of machinery service, preventative maintenance, condition monitoring and a series of maintenance. The system realizes the optimization of shop efficiency and maintenance. So the rolling bearing for certain industries, played a crucial role. When deep groove ball bearings appear the following, please do not continue to use, should immediately replace the new bearings. To avoid unnecessary accidents:
(1) rolling bearing inner ring, outer ring, rolling, cage any one has a crack or notch; (2) deep groove ball bearings inner diameter or outer diameter of the surface obvious creep; (4) the obvious discoloration caused by heat; (5) bearing the raceway surface, the rolling body on the rust, there is injury; (3) bearing raceway surface, ribs, rolling significant card injury; (6) Bearing raceway surface, rolling the body has a serious indentation and marking; (7) bearing rings, rolling on any one of the fracture; (8) bearing the cage wear significantly, or significant rivets relaxation .
1, the force point even symmetry and smooth, through the spherical or parallel to the axis of the force, force together as far as possible through the rolling bearing axis.
2, the use of oil pressure or the use of a smooth pull or pressure can be applied to the tool, the size of the force should be smooth and uniform, should not have the impact, if necessary, can be hammered, hammered through the copper sleeve, Metal buffering, percussion force as much as possible. It is best to use a copper bar or a copper hammer for hammering.
3, Assembly and demolition of the inner ring (shaft ring) through the inner ring force, assembly and disassembly of the outer ring) through the outer ring force, to avoid the force through the rolling body.
4, the installation of rolling bearings should be installed in the right position when the bearing to stop the force to ensure that the end of the ring (washer) against the seat hole or shaft end of the shoulder, can not be packed too tight, can not be installed in place, Force to continue to the extent that should be.
|
|
|
