Regular inspections of large clearance conveyor pulley bearing are essential to maintaining the best of large clearance conveyor pulley bearing, and also allow us to identify problems in a timely manner. The following large clearance conveyor pulley bearing in the use of the matters that should be noted for everyone to do the following details.
First of all, we want to emphasize that it is important to keep large clearance conveyor pulley bearing lubricated and clean.
So when we do a check on the large clearance conveyor pulley bearing, you should first clean the surface large clearance conveyor pulley bearing, and then remove the bearing around the parts. We should note that the oil seal is very fragile parts, so check and dismantling the need for extra care, do not over-force, so as not to cause damage to parts. And then carefully check the large clearance conveyor pulley bearing oil seal and its surrounding parts, if it has been showing a bad symptoms, be sure to replace the bad oil seal will lead to damage to the bearing, so that large clearance conveyor pulley bearing clouds are not normal and cause equipment downtime.
Secondly, we also check the large clearance conveyor pulley bearing lubricant.
Lubrication is very important, not only for large clearance conveyor pulley bearing, but also for all imported bearings. However, please note that large clearance conveyor pulley bearing should not be added too much grease.
The inspection method of large clearance conveyor pulley bearing lubricants is:
Stained with little lubricant in the friction between the two fingers, if contaminants exist, can be felt out; or in the back of the hand painted a thin layer of lubricant, and then sealed light inspection.
Then replace the large clearance conveyor pulley bearing lubricant.
After using the old oil, if possible, fresh oil should be poured and let the machine spin at low speed for a few minutes. As much as possible, allow the oil to collect the remaining contaminants, and then diarrhea in addition to these oils. Note: oil is best filtered before use.
The use of grease lubrication large clearance conveyor pulley bearing in the replacement of grease, the Joe used to remove the device with the cotton material should be avoided to any part of the angle. Because these residual fibers may wedge between the rolling elements and cause damage, especially the application of small bearings need to pay more attention to this problem.
Contact Us
Shandong Xinkaite bearing Co.,Ltd.
Unified Social Credit Code:9137 1525MA3C 5428XP
Address:Xu Village Industrial Garden,Gan Town,Guan County,Shandong
Phone:086+0635-5638235 Fax:086+0635-5638808
Mobile Phone:086+15563545668
Email:xkte@xinkaite.com